×

All Options are Required.

Skip to product information
1 of 4

SKU:DSEBK97

Dieselsite 7.3L Intake Plenum Boots - 1994-2003

Dieselsite 7.3L Intake Plenum Boots - 1994-2003

No reviews

Regular price $89.00
Regular price Sale price $89.00
Sale Sold out

View full details


DIESELSITE INTAKE PLENUM BOOTS


This kit includes the two boots that connect the intake manifold piping ("Spider") to the intake plenums on 19994-2003 7.3L PSD trucks.  Also included are four worm gear drive clamps.  

If you have upgraded your intake plenums to a billet aluminum style, or if you have purchased the DIESELSITE no-crush plenum inserts, you may upgrade to spring-loaded T-bolt clamps 

THESE BOOTS ARE NOT FOR USE ON THE INTERCOOLER PIPING!

Stock boot material is silicone. However, this type of material is NOT oil compatable. This is unacceptable in our application as the Powerstroke incorporates a closed crankcase vent system. This means oil travels thru the intake and comes in constant contact with the boots. This oil contact causes deterioration and leaks due to the incompatibility of the silicon boots and the oil from your crankcase. In fact, if you have seen an oil mist all over the valley of your PSD and wondered where it was coming from, chances are it was caused by leaking, deteriorated stock boots. The stock boots WILL leak air and oil. In many cases, 3-4psi leaks are very common.

As an added bonus, this boot kit will keep those who put out higher than normal boost numbers from "blowing boots". Higher boost in the PSD can stretch the limits of a saturated set of factory boots and could blow your boots right off. In some cases, guys with numbers MUCH lower still running the stock boots saturated with oil, having lost their integrity and gripping ability can have their boots slip off as well. Not quite as dramatic, but still a bummer. Even a stock truck can have problems keeping boots on if they become saturated with oil.

As with all Dieselstie parts, these are QUALITY PARTS. We ordered sample upon sample of hose material and clamps until we were satisfied with the quality of the parts and certain of their integrity in our application. Our boots are made of hose that is reinforced with synthetic fabric. It will not kink or collapse. The special synthetic rubber is exceptionally resistant to oil, heat, ozone, gasoline, gasohol, methanol, ethanol and diesel fuel. It can withstand engine heat and 100psi boost pressure. This is virtually "indestructable" boot material.

 -------------------------------------------------------------------------------------------

 

A little specific info on our boots.

Our boots are Flourolastomer lined to handle oil, heat, etc. They have a 5 ply braided center section, and a textured outer rubber cover to grip on to the clamps.

Fluoroelastomers are synthetic, rubber-like materials used in gaskets, O-rings and hoses. Their unique properties make these products ideal for high-performance aerospace and automotive applications or environments that are extremely harsh and challenging.

These are not cheap silicon hoses. These are top quality (best that can be made) tubes that are indivdually molded. These are not cut sections of some hose length. The most important thing you need to know is : Silicone hose is NOT compatible with fuel or oil.

There are other options out there for cheap hoses, like those that sell silicon hoses, but for those that want the absolutely best hoses you can buy, we made the units you see on our web site.

---------------------------------------------------------------------------------------------