Global supply chain disturbances may cause shipping delays
Product Search

    Secure Checkout
    6.0L Intercooler Swap Boot Kit for 7.3L

    Thumbnail Filmstrip of 6.0L Intercooler Swap Boot Kit for 7.3L Images

      Purchase 6.0L Intercooler Swap Boot Kit for 7.3L

      SKU: DSIBK6SW
      6.0L Intercooler Swap Boot Kit for 7.3L

      Not Yet Rated!

      $152.50

       



      6.0L Intercooler Swap Boot Kit for 7.3L

      This boot kit is designed to allow the installation of the 6.0L intercooler into the 7.3L Ford Powerstroke. Stock boot material is silicon. However, this type of material is NOT oil compatible. This is unacceptable in our application as the Powerstroke incorporates a closed crankcase vent system. This means oil travels thru the intake and comes in constant contact with the boots. This oil contact causes deterioration and leaks due to the incompatibility of the silicon boots and the oil from your crankcase. In fact, if you have seen an oil mist all over the valley of your PSD and wondered where it was coming from, chances are it was caused by leaking, deteriorated stock boots. The stock boots WILL leak air and oil. In many cases, 3-4psi leaks are very common As an added bonus, this boot kit will keep those who put out higher than normal boost numbers from "blowing boots". Higher boost in the PSD can stretch the limits of a saturated set of factory boots and could blow your boots right off. In some cases, guys with numbers MUCH lower still running the stock boots saturated with oil, having lost their integrity and gripping ability can have their boots slip off as well. Not quite as dramatic, but still a bummer. Even a stock truck can have problems keeping boots on if they become saturated with oil. Our boots have been tested to 50+ lbs. of sustained boost in a PSD with single clamps only and have held. With multiple clamps, higher boost numbers are no problem for our boot kit. We currently run 54 lbs.+. These are the same type of clamps that twin turbo setups run. The kit includes the two boots that connect the intercooler pipes to the intercooler. One boot is 3" x 3.25"ID and the other boot is 3" ID x 3" ID. They are longer than the 7.3L OEM boots to make the installation easier. It includes four T-bolt spring clamps. The spring bolt clamps are 300 series stainless steel with zinc coated bolts with a 300lb clamping strength. Recommended torque is 60 in/lbs. Extra clamps are available as an option for severe boost numbers. Our boots are made slightly longer than stock in order to accommodate multiple clamps. In most cases, what is supplied will more than suffice the normal user.

       

      DSIBK6SW

      Customer Reviews

      Write a Review
      Review 6.0L Intercooler Swap Boot Kit for 7.3L
      No Reviews Yet!