Contact Us
Based on the measurements you provided, we couldnāt match any products. Please provide your email and phone number, and we will reach out to you during business hours.
SKU:Ford-SRP-PA85019
80-97 F-250/350 Pitman Arms
80-97 F-250/350 Pitman Arms
Please select a valid combination of attributes.
Sky's flat pitman is the stock 85-97 F350 4x4 pitman arm. It is longer than all the other OBS pitman arms and is necessary to get full turning radius from the Dana 60 axle.
When swapping a Dana 60 this is necessary, this is also the pitman used in crossover steering kits with less than 8" lift.
CHOOSE STOCK APPLICATION FOR OPTIONAL REAMING UNLESS YOU'RE SWAPPING IN A 05+ COIL SPRING AXLE OR USING GM TIE ROD END
F-350, factory Dana 60 axle
If you're installing the 3 inch reversal usingĀ stock worn out springs, we don't feel its necessary. The reason is, you're not gaining 3 inch's of lift over stock, your compensation for old springs, probably only gaining 1.5 -2 inch of lift, some times less.
F-250 installing a reversal and Dana 60 80-97 axle
The F-250 has a shorter throw than the F-350, so to get full turning radius you need to either swap on the Factory F-350 arm or our drop arm. The determining factor is if you are using new F-350 springs, or refreshed as some springs shops term it, you should use the drop arm, which is only actually 2 inch's of drop over the f-250 arm, but longer to allow full steering. If using worn out springs, then switch to a stock F-350 arm.
-5 inch Shackle reversal under anything
Yes, its a 5 inch lift, and if your adding it to other springs you need either our Ball Joint 60 crossover kit, or a king pin 60 cross over steering kit depending on donor axle, not just a pitman arm.
