Sky Manufacturing, 1980 - 1997 Dana 60 High Steer Kit With Reid Knuckles
NOTE: Steering kits are built to order and take up to 5 days to build. Due to confusion, this does not include weekends and other lead times noted on the website, these kits cost far less than any comparable USA made kits on the market, and are very high in demand!
Knuckles come Drop Shipped from Reid Racing.
Dana 60 Full High Steer Kit with Reid Knuckles. Works with all king pin Dana 60 axles.
Full High Steer with Reid knuckles includes the following:
1 - Driver Side Steering Arm
1 - Passenger Side Steering Arm
2 - Grease Zerts
8 - 1/2" Steering Arm Studs
8 - 1/2" Wheel Nuts
1 - Tie Rod
1 - Draglink
2 - Left Hand Thread 7/8" Tie Rod Ends
2 - Left Hand Thread 7/8" Jam Nuts
2 - Right Hand Thread 7/8" Tie Rod Ends
2 - Right Hand Thread 7/8" Jam Nuts
1 - Pitman Arm
1 - Passenger Side Reid Knuckle
1 - Driver Side Reid Knuckle
Steering Links are trimmable! Sky gives at least an inch on each side extra to be safe.
REID KNUCKLES:
The strongest Dana 60 knuckles on the market, cast from high strength ductile iron and beefed up with extra material and ribbing. 100% interchangeable with a Ford Chevy Dodge kingpin knuckle, except uses stronger Chevy tie rod ends. 5 holes to accept 5 stud arms (4 bolt arms still fit).
Cast in steering stop eliminates bent stop bolts. Ford Knuckles accept one-ton Ford brakes with no modifications required. Tie rod holes can be drilled to accept 3/4" rod end. Powder coated bright orange for long lasting looks, fully machined and ready for installation!